INHALOTHERAPY DRYING UNIT MODEL USEI-2005 OTSA

Hot Air Recirculation and Other Exclusive Features

Manufacturas OTSA, SA de CV is a company with more than 30 years of experience in the design and manufacture of fine and quality medical equipment. Its hospital line is intended to cover the needs of laboratories, clinics, the pharmaceutical industry, the food industry, among others, and complies with the strictest international construction and operation standards.

Sterile Tube Dryer, Inhalotherapy and Anesthesia Equipment, Based on Laminar Flow

Features:

• Fixed Electro-Hydraulic Equipment.
• Controlled by Microprocessor.
• Built entirely of Corrosion-proof Aluminum.
• Drying Module.
• Hot Air Recirculation System for Fast Drying.
• Overall dimensions:
  • 220 cm height
  • 120 cm wide
  • 52 cm of depth
• Electrical Supply: 120V, 60HZ.
• Resistor Capacity: 1800 watts.

Other Exclusive Features:

• Microprocessor that controls drying times and temperature up to 4 hours with On/Off pilot light and Audible Alarm that indicates end of cycle.
• 2 Drying Booths:
  • One to place trays with rails at different heights.
  • The other with clips to hang tubes.
• For easy loading, the tube holders slide out to a convenient height.
  • Accepts tubes up to 5 ft long.
  • Tube holders can be replaced with parts trays or bag dryers.
• Prefilters: Removes large particles front mounted for easy replacement.
• 100% High Efficiency Certified Hepa Filters: Removes all particles larger than 0.3 microns that carry bacteria and viruses.
• Removable trays to place the material:
  • 3 large trays of 46 x 46 cm.
  • 2 trays of 46 x 23 cm.
  • All coated to avoid burns to the touch.
• 2 transparent doors that allow you to observe the material in process.
• Pre-filtered air inlet on top front for large particles.
• Separate Fans: Each chamber has its own fan for quiet operation and high air volume.
• Insulation in the walls that retains more than 80% of the hot air which recirculates through the Hepa Filter, making drying more efficient.
  • Typical process time is 40 minutes.